The TV is not on JubileeTV's HDMI port
Overview
If your TV screen shows its native "Smart TV" menu, a "No Signal" message, or the screen for another device attached directly to the TV (not attached to the JubileeTV Console), your television is likely on the wrong HDMI Input.
The best way to prevent this is to enable CEC (Consumer Electronics Control). This technology allows your JubileeTV Remote to automatically switch the TV back to the correct input the moment you press a button.
Additionally, most modern TVs allow you to change their startup behavior so they always turn on to a specific HDMI port or remember the last one you used. See Setting Your TV to Start on JubileeTVad for instructions.
Note: If your TV does not support these features, you must use the TV's original remote to manually switch back to the JubileeTV HDMI port.
How to Enable Refresh CEC
To enable CEC on your TV, you need to access the settings menu of the TV itself (not the JubileeTV menu).
- Using the TV's Original Remote: Open your TV's Settings menu.
- Locate CEC Settings: Navigate to the System or Input menu. Note that most manufacturers use a custom name for CEC (see the list below).
- Toggle the Setting:
- If it is already ON, switch it to OFF, wait 10 seconds, and turn it back ON
- If it is OFF, switch it ON.
Common Names for CEC
Look for these brand-specific terms in your TV's menu:
- Samsung: Anynet+
- Sony: BRAVIA Sync (or BRAVIA Link)
- LG: SimpLink
- Panasonic: VIERA Link (or HDAVI Control / EZ-Sync)
- Philips: EasyLink
- Sharp: Aquos Link
- Toshiba: Regza Link (or CE-Link)
- Insignia: INlink
- Hitachi: HDMI-CEC