---
title: The TV is not on JubileeTV's HDMI port
slug: the-tv-is-not-on-jubileetvs-hdmi-port
docTags: 
createdAt: 2026-04-15T16:03:52.299Z
---

# Overview

If your TV screen shows its native "Smart TV" menu, a "No Signal" message, or the screen for another device attached directly to the TV (not attached to the JubileeTV Console), your television is likely on the wrong **HDMI Input**.

The best way to prevent this is to enable **CEC (Consumer Electronics Control)**. This technology allows your **JubileeTV Remote** to automatically switch the TV back to the correct input the moment you press a button.

Additionally, most modern TVs allow you to change their startup behavior so they always turn on to a specific HDMI port or remember the last one you used. See [Setting Your TV to Start on JubileeTV](docId\:qRnwkFEGYb-LsjDeCv6zB) for instructions.

**Note:** If your TV does not support these features, you must use the **TV's original remote** to manually switch back to the JubileeTV HDMI port.

# How to Enable Refresh CEC

To enable CEC on your TV, you need to access the settings menu of the TV itself (not the JubileeTV menu).

1. **Using the TV's Original Remote:** Open your TV's **Settings** menu.
2. **Locate CEC Settings:** Navigate to the **System** or **Input** menu. Note that most manufacturers use a custom name for CEC (see the list below).
3. **Toggle the Setting:** 
   - If it is already **ON**, switch it to **OFF**, wait 10 seconds, and turn it back **ON**
   - If it is **OFF**, switch it **ON**.

### Common Names for CEC

Look for these brand-specific terms in your TV's menu:

- **Samsung:** Anynet+
- **Sony:** BRAVIA Sync (or BRAVIA Link)
- **LG:** SimpLink
- **Panasonic:** VIERA Link (or HDAVI Control / EZ-Sync)
- **Philips:** EasyLink
- **Sharp:** Aquos Link
- **Toshiba:** Regza Link (or CE-Link)
- **Insignia:** INlink
- **Hitachi:** HDMI-CEC